APPLICATION PROCESS 1.PREPARE: Protect surfaces not intended to be treated. Ensure that walls, mulch borders and other surfaces are protected as needed. Ensure proper surface temperature. Ensure ambient air temperature stays above 32 F until product is dry. If temperature falls below 32 F, performance of the product may be adversely affected. Use the proper equipment. 2.TEST: Perform a small test area (at least 2 sq. ft.) using the product to ensure suitability and the desired results prior to full application. Test for application coverage rate. Use the same preparation, equipment and conditions expected during the entire application. 3.APPLY: Before use, consult our website to ensure proper application techniques, including review of the Technical Data Sheet. Do NOT Dilute or alter the product. Shake the container prior to use as some settling may have occurred. Generally, apply one coat of Mulch Anchor to your mulch. When spraying, use even, broad strokes to ensure uniform coverage. If additional hardening of the mulch is required, a second coat may be applied. Apply liberally to the mulch areas. Take necessary precaution not to apply to any surface not intended to be treated. Some settling may occur during application. If this happens, shake to container/sprayer enough to re-suspend the product and resume application. Allow sufficient dry times. Do not apply if rain is forecasted within a day. 4.CLEANUP: Place any unused product back into original container to store for future use. Any mixture exposed to air will harden in the container. Clean equipment thoroughly until free of product residue.